I-View FE-5MIPN 5-Megapixels IR Vandal Proof Dome IP Camera User Manual
Page 18
18
can select “Onvif” if your IP camera support Onvif compliant and not on the list. You can
check the used camera support Onvif compliant from: http://www.onvif.org. Click “ Onvif
setup “ icon to setup the parameters which you want to run on the Hybrid DVR or NVR.
Compress: Select the suitable codec for video recording and transmission.
Recording resolution: Select the resolution for video recording and display.
Frame rate: Select the frame rate for video recording and display.
Rate Control: You can choice video quality or bit rate from this tab. Good video quality or
large bit rate request bigger storage capability.
IP address: Entry the correct IP address for the connected IP camera. If you do not know the IP
camera’s IP address, you can click “Find” icon to find out the currently connected IP cameras
User name & Password: The user name and password must be matched the setting of IP
camera which you want to connect.
.The default User name / Password is “ admin / 123456 “ and IP address is 192.168.0.123.
Some special issues to cause cannot find out the IP address that you can try the
192.168.123.123
Find: Click this icon to find out all the currently connected IP cameras on the list. You will
find out the network information of each IP camera. Please refer the diagram shown as above
Fig A. Click the IP address and “Select” icon, the IP camera information will be show on.
System Firmware update: Click “System Firmware update icon” icon to update the
newest IP camera firmware; you can check and download the newest firmware version from
our website:
www.i-view.com.tw
.
Change IP: Click “Change IP” icon to setup the DHCP or Static IP address and also
modify the username /Password. Please refer to Fig B diagram. After modification, click
“Change” icon to confirm the setting.
Discover: Click “Discover” icon to research the IP address of system.
Reboot: Click “Reboot” icon to restart this IP camera.
Go Web: Click this icon to enable the I.E. Browser to check/setup the detail parameters.
Select: Choice the IP camera which you find out from the system and then click “Select”
icon to assign this IP camera into the camera channel of Witness NVR.