Kaiser AT6405 - Manual (Page 8)

•
• T
in the interior of
the device
• The power network
CONNECTING TO THE POWER NETWORK
Connect the hood to the power supply network.
Before connecting the oven to the mains power supply,
make sure that:
he supply voltage corresponds to the
specifications on the data plate
.
has an efficient ground
connection complying with all applicable laws
and regulations.
T socket is a legal
requirement. The power cable should never reach a
temperature 50 °C above ambient temperature at any
point along its length.
If the appliance is to be connected directly to mains
terminals, fit a switch with minimum aperture of 3 mm
between the contacts. Make sure that the switch is of
sufficient capacity for the power specified on the
appliance's data plate, and compliant with applicable
regulations. The switch must not break the yellow-
green earth wire. The socket or switch must be easily
reachable with the oven fully installed.
he according to the rules installed
After connecting the device to the power supply
network (in accordance with the requirements defined
above) it is necessary to check the lighting of the hood
and whether its motor works correctly.
EN
8
Attention! The manufacturer declines all
responsibility for damage or injury if the above
instructions and normal safety precautions are
not respected