MoTeC Snowmobile Plug-In ECU - Manual (Page 25)

MoTeC Options to Expand the System 17
Options to Expand the System
GPS
The M400 Marine ECU can receive GPS data via RS232 communication,
which allows wiring MoTeC's 5 Hz GPS-G1 (#41300) direct into the ECU's
existing RS232 receive port. This GPS feature is an extremely useful
addition for Snowmobiles because conventional speed detection methods
are inaccurate.
The following GPS based channels are available: Speed, Time, Longitude,
Latitude, Altitude, Satellites, Quality, HDOP (Range Error).
For wiring information see the relevant calibration notes in the appendices.
To configure the GPS in ECU Manager software
1. On the Adjust menu, click General Setup.
2. Click Communications and then RS232 Telemetry Setup.
3. Enter Telemetry Baud Rate 19201.
4. Enter Telemetry Data Set 0 to turn the dataset Off.
Upgrades
The M400 Marine ECU comes with a range of features as standard and
several options available as upgrades to customise and grow your system.
These additional features are activated through a simple password
acquired from your MoTeC dealer, at any time when you need it.
Data Logging
To take full advantage of the possibilities of the system, data logging can
provide you with valuable knowledge about the performance and reliability
of the engine and vehicle.
The Snowmobile Plug-In ECU systems have the data logging option
enabled for a free evaluation period of the first 8 hours of engine running
time. After this, the Data Logging Upgrade is required which allows
recording of all ECU data to the 500 kB internal logging memory.
Wideband Lambda
Additional tuning of all Snowmobile Plug-In ECU installations is best
performed with a Lambda sensor.
The Snowmobile Plug-In ECU systems have the Lambda option enabled
for a free evaluation period of the first 8 hours of engine running time. After