Neff D5675X0 - Manual (Page 18)

18
Filters and maintenance
2. Press the retaining spring and remove
the filter frame.
3. Remove the wire grille and replace the
filter mat.
4. Install the filter frame in reverse sequence.
ṇ
Re-attach the retaining spring.
ṇ
The left and right sides of the filter
frame must lock into position!
Metal grease filter
The filter mat is made of non-combustible
metal.
Caution:
As it becomes more and more saturated
with grease, the filter also becomes
increasingly inflammable. The efficiency of
the extractor hood can also be adversely
affected.
Important:
Clean the metal grease filter at regular
intervals.
Cleaning the metal filter:
Under normal operating conditions (1 to 2
hours per day), the metal grease filter will
require cleaning after 8 to 10 weeks.
❑ The filter can be cleaned in a
dishwasher.
This can however cause slight
discoloration.
Important:
Metal filters that are heavily saturated with
grease should not be cleaned at the same
time as any crockery, etc.
❑ If the filter mat is going to be cleaned by
hand, soak it first of all in a hot deter-
gent solution for several hours.
Clean the filter with a brush, rinse it off
thoroughly and allow it to drip dry.
❑ Use only original replacement filters.
In so doing you will be ensuring that the
extractor hood performs as effectively
as possible.
Removing and installing the grease
filter
Extractor hoods with a filter mat :
1. Rotate the handles on the left and right
of the filter grille.
5750.196 433-NEFF.qxd 18.03.2009 8:54 Uhr Seite 18