Neff D5675X0 - Manual (Page 23)

ṇ
Old appliances are not worthless
rubbish. Valuable raw materials can be
reclaimed by recycling old appliances.
Before disposing of your old appliance, ren-
der it unusable.
ṇ
You received your new appliance in a
protective shipping carton. All packaging
materials are environmentally friendly and
recyclable. Please contribute to a better
environment by disposing of packaging
materials in an environmentally-friendly
manner.
Please ask your dealer or inquire at your
local authority about current means of
disposal.
ṇ
The extractor hood can be used in
exhaust air or circulating air mode.
ṇ
Always mount the extractor hood over
the centre of the hob.
ṇ
Minimum distance between electric hob
and bottom edge of extractor hood:
650 mm.
ṇ
The extractor hood must not be
installed over a solid fuel cooker – a
potential fire hazard (e.g. flying sparks) –
unless the cooker features a closed,
non-removable cover and all national
regulations are observed.
ṇ
The smaller the gap between the
extractor hood and hotplates, the greater
the likelihood that droplets will form on the
underside of the extractor hood.
Additional information concerning gas
cookers:
ṇ
When installing gas hotplates, comply
with the relevant national statutory
regulations (e.g. in Germany: Technische
Regeln Gasinstallation TRGI).
ṇ
Always comply with the currently valid
regulations and installation instructions sup-
plied by the gas appliance
manufacturer.
ṇ
Only one side of the extractor hood may
be installed next to a high-sided unit or high
wall. Gap at least 50 mm.
ṇ
Minimum distance on gas hotplates
between the upper edge of the trivet
and lower edge of the extractor
hood:
650 mm.
min 650
Installation Instructions:
Important information
23
5750.196 433-NEFF.qxd 18.03.2009 8:54 Uhr Seite 23