J&M HHS-42B - Manual (Page 11)

Pg. 11
SET-UP INSTRUCTIONS (continued)
7. Installing the Light Kit and Wiring Harnesses
A. Insert the Main Wiring Harness, end opposite the Seven Prong
Connector End, through the grommet located at the front of the
gooseneck of the Header Transport Main Frame and exit the A-
Frame behind the gooseneck.
B. Insert one Main Brake Harness, Long Light Harness Extension and
Side Light Wire through the right side grommet located behind the
gooseneck and extend the wires toward the rear of the Header
Transport Main Frame.
C. Insert the other Long Light Harness Extension and Side Light Wire
through the left side grommet located behind the gooseneck and
extend the wires toward the rear of the Header Transport Main
Frame.