J&M HS-36B - Manual (Page 10)

10
6. Header Transport Light Kit
Place Extension Bracket Arm (51) at rear end of Upper Bar (2). Attach using the two Angle Iron Supports (49)
and secure with four 1/2” x 5” bolts (50), four 1/2” washers (73) and four 1/2” lock nuts (5).
Place Light Mounting Bar (53) at the end of the Extension Bracket Arm (51) so the Light Mounting Bar is level
or horizontal and extends towards the center of the header transport. Secure using two 1/2 x 1 1/4” Grade 5
Flange Bolts (86) and two 1/2” Whiz Nuts (87).
Mount each Rear Light Assembly (54)(55) at the end of the Light Mounting Bar (53) so the reflective side lense
is positioned toward the outside of the transport. Secure each light assembly using four small Self-tapping
Screws (27). Secure the Rear Light Panel (56) to the center of the Light Mounting Bar (53) using four 1/4” x 1”
Bolts (58) and four 1/4” Lock Nuts (85).
7. Installing the Light and Electric Brake Wiring Harnesses
A) Insert the Main Wiring Harness, end opposite the 7-Prong Connector End, through the grommet located at
the front of the gooseneck of the Header Transport Main Frame and exit the A-Frame behind the gooseneck.
B) Extend the Main Wiring Harness along the inside right side of the Header Transport Main Frame. Reinsert
the Main Wiring Harness through the opening located along the front of the A-Frame and extend the harness
through the main frame tubing toward the rear of the transport.
C) Exit the Main Wiring Harness at the opening located adjacent to the two rear axles. Extend the Main
Wiring Harness along the top of the front Dura-Flex Rear Axle.
D) Connect the wire to each of the side marker lights located on the outside of the rear fenders and the center
of the Header Transport Main Frame. Extend the wires along the top of the Header Transport Main Frame to
the end of the Main Wiring Harness.
E) Connect the brake wires to each of the brake clusters located on the rear axles and extend the wires along
the top of the Header Transport Main Frame to the end of the Main Wiring Harness.
F) Extend the Light Wiring Harness through the Light Mounting Bar and connect to both the Rear Red Lights
and Light Mounting Bar. Insert the Light Wiring Harness through the Upper Bar and exit at the opening near the
Dura-Flex Rear Axles. Proceed the wire harness along the top of the Header Transport Main Frame to the Main
Wiring Harness.
SET-UP INSTRUCTIONS (Continued)
55
57
53
86
68
51
5
50
2
67
73
56
22
66
54
87
49
67
68