J&M HS-36B - Manual (Page 8)

8
3. Mounting the Rear Fenders
Place one of the Base Fender Support Rail (Left or Right) (45L
and 45R) on top of the two rear axles between the main frame
and spindle as shown. Align the holes in the support rail with
the rear axles and loosely secure to each axle using one 3/8”
x 3 1/2” x 3 1/2” U-Bolt (80), two 3/8” flat washers (78) and two
3/8” lock nuts (79). IMPORTANT: Be sure the vertical face of
the support rail faces the outside of the transport (toward the
tires) and the support rail extends farther behind the second
rear axle (A) than it does the first rear axle (B). If the support
rail does not project farther behind the second rear axle, the
rail is located on the wrong side of the transport and the other
rail should be used.
Repeat on opposite side of transport.
Slide the Fender Support Arm (44) across the header transport
main frame and loosely secure to the Angle Iron Support (49)
using two 1/2” x 1 1/2” Grade 5 bolts (29), two 1/2” washers
(73) and two 1/2” lock nuts (5). Mount the Fender to the top of
the Fender Support Arm using two 3/8” x 1” flange bolts (21),
two 3/8” rubber/metal washers (81) and two 3/8” whiz nuts
(82). Be sure the side tear drop of the fender is located toward
the outside of the transport. Slide the Fender Support Arm
along the main frame until the Fender is centered above the
tires to ensure proper clearance.
Repeat on opposite side of transport.
SET-UP INSTRUCTIONS (Continued)
Mount one Fender L-Brackets (77) to each inside end of the
fender using two 3/8” x 1” flange bolt (21), two 3/8” washers
(81) and two 3/8” whiz nuts (82) as shown. Secure the other
side of the L-Bracket to the Base Fender Support Rail using
two 3/8” x 1” flange bolts (21) and two 3/8” whiz nuts (82).
Repeat on opposite end of fender.
Repeat on opposite side of transport.
A
B 45
78 80 79
29
49
44
21
47
81
82
73 5
82 21
45
77
21 78 82