J&M Roll Tarp GRAIN CARTS (June 2011 & newer) - Manual (Page 12)

12
Install Stop Tube
Insert Roll Tarp Tubes
Prepare the canvas tarp. Spread the canvas tarp our so that the 3 stiffening patches are on the opposite auger side
with the schiney part down. Install the 1-1/4” steel tube through the opposite auger side canvas tarp end. Then
feed the 1” steel tube through the auger side tarp end.
CANVAS TARP
1-1/4” S
te
el T
ub
e
1” S
te
el T
ub
e
Front Corner of Cart
On the auger side of the grain cart, measure 2” from the end of the tube. This is where the canvas tarp should
stop. Now measure 3/4” over onto the canvas tarp. Drill a 1/4” hole through the tarp and the first wall on the
tube. Next install a pop rivet using a hammer. Now go to the opposite end of the same tube and pull the tarp
tight. Measure 3/4” from the end of the tarp, drill a 1/4” hole and install another pop rivet.
2”
3/4”
Tools Needed:
1/4” Drill Bit
Hammer
1” Steel Tube
1-1/4” Steel Tube