J&M Roll Tarp GRAIN CARTS (June 2011 & newer) - Manual (Page 13)

13
Install Pop Rivets on Roll Tube
Install the Roll Tarp Stops
Line the roll tube spool up with the spring return cable. Drill a 1/4” hole through the first stiffening
patch. Fasten the canvas tarp using a pop rivet. Go to the rear of the cart, pull the canvas tarp tight, and
repeat the process. Then install pop rivets at the remaining stiffening patches. Once finished slip the
Spring Return cable loop over the spool.
Next place the 1” tube under the top bolt of the corner bracket. Drill a 1/4” hole approximatley 18” to 24” in
from the corner of the cart. Then redrill the hole with a 7/16” bit. Place a 3/8” x 2”bolt through the 1” tube and
grain cart sidewall. Fasten with a 3/8” serrated flange nut. Now repeat this process at the front and middle of
the cart.
18”-24”
Tools Needed:
1/4” Drill Bit
7/16” Drill Bit
9/16” Socket & Wrench
Tools Needed:
1/4” Drill Bit
Hammer
1” Steel Tube