J&M Uni-Swivel Hydraulic Auger - Manual (Page 10)

10
UNI-SWIVEL HYDRAULIC AUGER INSTALLATION
Remove the plastic plugs from the hydraulic motor at the base of the auger and attach the two 1/2” hydraulic
hoses. (NOTE: The SUPPLY hose will be the one connected directly to the motor valve and the
RETURN hose will be the one connected to the motor valve.) Attach the coupler bracket to the brace
inside front leg of the gravity box using one 3/8” x 1” bolt and lock nut. Attach hydraulic hoses. Secure the
hydraulic hoses to the box runner using the 9” rubber strap. (Place the rubber strap as close to the center of
the box as possible to keep the hydraulic lines away from the tire.)
Position the Hose Holder Bracket to the side rail (far side) of the ladder. Sandwich the tractor hydraulic hoses
(not included) between the side rail of the ladder and the hose holder bracket using (2) - 3/8” x 1 1/2” bolts and
nuts.
Winch the auger down to the lowest position. Attach the 6” rubber spout (or optional 3-Stage Telescoping
Spout) using the 6” black clamp. Clamp together using on 3/8” x 1 1/2” bolt and one 3/8” lock nut. Attach the
J-Bolt to the top bracket with hook end on the same side as the control rod. Attach one 5/16” pulley to the J-
Bolt. Attach the other pulley to the control rod. Loop the 5/16” rope through the pulleys and attach to the J-
Bolt. Slip the Plastic Rope Handle onto the rope through the small holes in the handle. Adjust the handle along
the length of the rope to the end of either the 4’ rubber spout or the 3-Stage Telescoping Spout.
5
6
5/16" Pulley
5/16" Pulley
J-Bolt
Control Rod
Rope
SUPPLY HOSE
RETURN HOSE