CEMB USA C202 - Manual (Page 17)

I 0592 - 17 GB
5.5.2 - “SPLIT” control
The SPLIT function is only possible in the case of static unbalance or ALU on the outside. It serves for concealing
any stick-on unbalance correction weights behind the rim spokes.
►
PRESETTING THE NUMBER OF RIM SPOKES
From the STATIC or ALU measurement screen, press ;
A window appears on the display indicating the currently preset number of spokes
Set the required number of spokes in the range 3 to 12 by pressing and
Press to confi rm the presetting
Bring a spoke to the 12 o’clock position
Press ; the measurement screen reappears with the unbalance values already split
The ALU unbalance on the inside does not vary while as regards the STATIC unbalance and that ALUS on the
outside, two weights appear for the same side:
Gradually turn the wheel until an unbalance value appears;
Apply an adhesive weight of the value indicated on the screen for the outer or STATIC side, behind the
spoke in the 12 o’clock position;
Again turn the wheel until a new unbalance value appears;
Apply an adhesive weight of the value indicated on the screen for the outer or STATIC side, behind the
spoke in the 12 o’clock position;
Perform a run to check for correct wheel balancing.
Note: when SPLIT is enabled, the icon is shown on the left of the screen.
▪
▪
▪
▪
▪
▪
▪
▪
▪
▪
▪