CHIEF WP2XS_WP2XUS User Manual
Page 12
WP2XS, WP2XUS
Installation Instructions
12
Adjustments
Distance from Wall / Screen Size (See Figure 15)
1.
Loosen two Phillips screws (one on left, one on right).
2.
Slide the RSA mount along the projector arm (A), as
required.
3.
Tighten two Phillips screws.
Yaw Adjustment (See Figure 15)
4.
Loosen yaw adjustment screw using a 5/32" hex key.
WARNING:
Do NOT turn the RSA to the end of the pipe
threads. The projector, interface bracket and RSA will fall
from the pipe if it is unthreaded too far!
5.
Adjust projector by turning the RSA on the pipe to the
desired position.
6.
Tighten yaw adjustment locking screw using a 5/32" hex
key.
Pitch Adjustment (See Figure 15)
NOTE:
Use a level to make this process easier.
7.
Loosen two Phillips screws (one on right, one on left).
8.
Tip up or down, as required.
9.
Tighten two Phillips screws.
Roll Adjustment (See Figure 15)
NOTE:
Use a level to make this process easier.
10. Loosen one Phillips screw.
11. Adjust horizontal tilt, as required.
12. Tighten one Phillips screw.
Figure 15
Projector Arm Height Adjustment
13. Loosen two Phillips screws (one on left, one on right) on
sides of projector arm plate. (See Figure 16)
14. Adjust the angle of the projector arm to counteract the
projector weight.
•
Turn counterclockwise to lower projector arm angle.
•
Turn clockwise to raise projector arm angle.
15. Tighten two Phillips screws (one on left, one on right) on
sides of projector arm plate. (See Figure 16)
Figure 16
Cable Management (Optional)
1.
Route cables/cords from projector through opening on
projector arm and route to wall. (See Figure 17)
2.
Guide cables/cords from wall end of projector arm
downward through slots in wall plate. (See Figure 17)
Figure 17
10
11
12
1
2
3
x 2
4
5
6
x 2
x 1
7
8
9
x 1
(SSBU and
(A)
(RSA
mount)
projector not shown)
13
15
14
OR
2
2
1
Cable management
covers
Cable
(examples)
OR