Installation – CHIEF WP2XS_WP2XUS User Manual

Page 6

Advertising
background image

WP2XS, WP2XUS

Installation Instructions

6

INSTALLATION

The WP2XS/WP2XUS short throw projector mounts are
designed to be mounted to an 8" concrete, 8"x8"x16" concrete
block, clay brick, 2" x 4" wood studs (16" on center), or steel
studs wall.

NOTE:

Proceed to the Concrete, Concrete Block or Clay

Brick, Wood Studs or Steel Studs Installation
Installation
section, as appropriate for installation.

Concrete, Concrete Block or Clay Brick
Installation

1.

Determine mounting location on wall.

2.

Using wall plate (E) as a template, mark four holes through
mounting holes in wall plate. (See Figure 1)

3.

Drill four 3/8" holes at marked locations in wall. (See Figure 1)

4.

Install four anchors (K) into drilled holes. (See Figure 1)

5.

Install four 5/16 x 2-1/2" hex head lag screws (G) through
four 5/16" washers (F), holes in wall plate (E) and into four
anchors (K). (See Figure 1)

NOTE:

Proceed to Install Short Throw Projector Arm to

Wall Plate section to continue installation.

Figure 1

Wood Studs Installation

1.

Determine mounting location on wall. Use a stud finder to
locate studs.

2.

Using wall plate (E) as a template, mark four holes through
mounting holes in wall plate. (See Figure 2)

3.

Drill four 7/32" holes at marked locations in wall. (See
Figure 2)

4.

Install four 5/16 x 2-1/2" hex head lag screws (G) through
four 5/16" washers (F), holes in wall plate (E) and into four
pilot holes. (See Figure 2)

Figure 2

NOTE:

Proceed to Install Short Throw Projector Arm to

Wall Plate section to continue installation.

Steel Studs Installation

WARNING:

IMPROPER INSTALLATION CAN LEAD TO

EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! The following figure
identifies the minimum requirements for installation of mount
onto a steel stud structure. If the structure or its components
do not meet these requirements contact the mount
manufacturer for specific instructions before attempting
installation. It should also be noted that no other equipment
should be mounted to the same stud. (See Figure 3)

2

3

x 4

4

(K) x 4

5

(G) x 4

(E)

(F) x 4

2

3

x 4

(E)

4

(G) x 4

(F)

Advertising