CHIEF AN1 Series User Manual
Page 11
Installation Instructions
AN1 Series
11
Projector Adjustments
Yaw Adjustment
1.
Loosen yaw adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 13)
2.
Turn yaw micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten yaw adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 13)
Figure 13
Pitch Adjustment
1.
Loosen pitch adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 14)
2.
Turn pitch micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten pitch adjustment locking screw using a #2 Phillips
screwdriver.
Figure 14
Roll Adjustment
1.
Loosen roll adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 15)
2.
Turn roll micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten roll adjustment locking screw using a #2 Phillips
screwdriver.
Figure 15
1
3
2
1
3
2
1
3
2