CHIEF AN1 Series User Manual
Page 9
Installation Instructions
AN1 Series
9
Installing Projector
1.
Attach projector interface (T) to projector using four
M4 x 10mm Phillips cap head screws (J). (See Figure 8)
Figure 8
2.
Lift projector with attached interface (T) and slide buttons on
interface into slots on boom projector mount (V). (See
Figure 9)
Figure 9
3.
Slide latch to LOCKED position to lock projector in place.
(See Figure 9)
Installing Control Housing
1.
Open door on control panel assembly (U).
2.
Insert edges of control panel assembly (U) into groove in
screen frame, with tab placed behind screen. (See Figure 10)
3.
Slide control panel assembly up along side of screen
assembly to the desired height. (See Figure 10)
Figure 10
4.
Determine attachment location on wall. (See Figure 10)
5.
Mark attachment hole through slot in control panel
assembly (U). (See Figure 10)
6.
Slide control panel assembly up or down, away from
marked hole.
7.
Drill one pilot hole (see Table 1 for size) at location marked
in Step 5 (See Figure 10) and follow fastener information
(appropriate for wall type) located in Table 1.
8.
Proceed to Fastener Installation Methods section at end
of Installation Instructions.
(J) x 4
1
(T)
Buttons
Slot
(V)
(T)
2
LOCKED
3
Latch
Slot
(U)
3
Screen
Attach to wall
through this slot
4
7
5