CHIEF SL220 - Manual (Page 10)

SL220 Installation Instructions
10
IMPORTANT ! : Select power cord (W or X) suitable for
location. If neither of those cords are suitable for your location,
use a power cord that has an attachment plug on one end that
meets IEC-60320 and on the other end is appropriate for use
with the grounded main outlet.
2. Plug power cord into IEC inlet on rear panel inside SL220.
(See Figure 11)
Figure 11
WARNING: PINCH HAZARD! FINGERS OR HANDS
BETWEEN MOVING PARTS CAN LEAD TO SEVERE
PERSONAL INJURY! Keep fingers and hands away from
mount when operating.
3. Open and fully extend SL220 using remote control
following instructions included with the remote control and
instructions in the Remote Control Capabilities section.
4. Remove power cord.
Removing Projector Cradle (Optional)
NOTE: Removing the projector cradle is optional, but
recommended for a single person installation. If NOT
removing projector cradle, proceed to Placing SL220
into Ceiling Structure section.
1. Remove and save Phillips head screw and disconnect the
grounding strap leading from inside front of SL220 to
projector cradle. (See Figure 12)
2. Loosen the screws in the linkage on each side of projector
cradle at rear of SL220. (See Figure 13)
3. Gently pull projector cradle away from sides at rear of
SL220. (See Figure 14)
4. The forward/aft adjustment screws may need to be
loosened for this. If so, loosen the screws, but do NOT
remove the screws. (See Figure 13)
Figure 12
Figure 13
(Some parts removed
for clarity)
2
Plug in
power cord
IEC inlet
Front of
SL220
x 1 1
Grounding strap
x 2 2
Front of SL220
Adjustment
screws
Adjustment
screws