Assembly and installation – CHIEF PACCC1 User Manual
Page 5
Installation Instructions
PACCC1
5
Assembly and Installation
Accessory Assembly - PACCC1 Alone
The PACCC1 is designed to accommodate both 200 x 200
VESA and 14" x 14" display mounting patterns. If 200 x 200
pattern is required use the inner mounting holes when installing
uprights (A and C). (See Figure 1)
NOTE:
The 14" x 14" display mounting pattern is NOT identical
to a 400 x 400 VESA display mounting pattern.
IMPORTANT ! :
If installing the PACCC1 with the PACLR1,
proceed to the "Assembly using PACLR1" SECTION!
1.
Install four mounting buttons (D) to uprights (A and C) and
center plate (B) using four #10-24 x 7/8" button head cap
screws (E) and four #10-24 lock nuts (G). (See Figure 1)
2.
Finish connecting uprights (A and C) to center plate (B)
using two #10-24 x 1/2" button head cap screws (F) and two
lock nuts (G). (See Figure 1)
Figure 1
Assembly Using with PACLR1
IMPORTANT ! :
When installing the PACCC1 to the PACLR1,
the uprights shipped with the PACCC1 will NOT be used as the
uprights already installed on the PACLR1 are identical.
1.
Remove two lower mounting buttons from uprights on
PACLR1. (See Figure 2)
2.
Hang top mounting flange of PACCC1 over the top of the
lower speaker rail on the PACLR1. (See Figure 2)
3.
Install removed two lower mounting buttons to uprights and
center plate (B) using screws and lock nuts removed in Step
1. (See Figure 2)
4.
Finish connecting uprights to center plate (B) using two #10-
24 x 1/2" button head cap screws (F) and two lock nuts (G)
as shown in Step 2 of the "PACCC1 alone" section. (See
Figure 1)
Figure 2
Install Speaker
1.
Loosen two button head cap screws securing speaker
mounting bracket to support plate using 1/8" hex wrench (J).
(See Figure 3)
2.
Reposition speaker mounting bracket to lowest position.
(See Figure 3)
3.
Tighten two button head cap screws securing speaker
mounting bracket to support plate using 1/8" hex wrench (J).
(See Figure 3)
1
(A)
(B)
(C)
(E) x 4
(D) x 4
(G) x 4
2
(F) x 2
(G) x 2
holes to use for
200 x 200 VESA mounting
1
3
2
PACLR1
PACLR1
(B)