CHIEF PACCC1 - Manual (Page 7)

Installation Instructions PACCC1
7
Figure 6
Adjustments
The PACCC1 allows for vertical adjustment of the speaker to
provide a flush installation against the bottom of the display.
The PACCC1 also provides up to 10 deg of YAW adjustment for
proper speaker alignment with bottom of display.
To adjust speaker vertical position:
1. Loosen two button head cap screws securing speaker
mounting bracket to support plate using 1/8" hex wrench (J).
(See Figure 7)
2. Reposition speaker up or down to desired position.
3. Tighten two button head cap screws securing speaker
mounting bracket to support plate using 1/8" hex wrench (J).
(See Figure 7)
Figure 7
To adjust speaker YAW position:
1. Loosen two button head cap screws securing speaker
mounting bracket to speaker vertical adjustment bracket
using 1/8" hex wrench (J) provided. (See Figure 8)
2. Reposition speaker to desired position.
3. Tighten two button head cap screws securing speaker
mounting bracket to speaker vertical adjustment bracket
using 1/8" hex wrench (J) provided. (See Figure 8)
Figure 8
Route cables and wires to display and speakers following
manufacturers installation instructions.
OPEN
2
3
4
5
Display
CLOSE
Latching Flag
2
3
1
x2
x2
(J) x1
3
1
x2
x2
(J) x1
2
Speaker Mounting Bracket