Analog Way Axion2 - Manual (Page 23)

21
4/ Press Black to adjust the levels of black for your Soft Edge. On
the Black tab, select the slave device you wish to work on, and
rotate the corresponding knobs to determine black levels for
your Soft Edge.
5/ Press the Blending tab to fine tune your Soft Edge. Select
a device in the dropdown menu, then, by rotating the
corresponding knobs, position the X and Y points of the
Blending curve, and increase or decrease their values to obtain
the desired onscreen balance for your Soft Edge.
6/ Press Pattern to go to the Patterns tab, and select the
appropriate patterns to setup and fine tune your Soft Edge
image. Choose amongst None, V. (vertical) Grey Scale, H.
(horizontal) Grey Scale, V (vertical) Color Bars, H. (horizontal)
Color Bars, Grid, SMPTE, Burst, Centering and Covering.
* TIP * : To configure your Soft Edge properly, you will probably need
to generate several types of patterns. Some patterns are dedicated
to video projector setup (like Grid or Centering), where others are
designed to adjust image blending (like Burst or Covering). Simply
select the pattern you want to use at any given stage, adjust your
settings, and return to the Patterns tab to change pattern for further
adjustments, or to remove it from your screen.
Soft Edge Setup
The Edit Soft Edge tab will be available only if the connected slave
device is being used in Embedded Soft Edge mode (for example a
Di-VentiX II) or if several devices are being used in Mixer Soft Edge
mode.
* TIP * : For more details on Soft Edge Blending, please refer to the
Soft Edge Blending chapter of this manual
1/ On the Screen Setup page of the Axion2 , press Edit SoftEdge.
2/ On the Soft Edge Setup page, you will find several tabs to
control and adjust your Soft Edge. Press on Soft Edge Type to
choose the type of Soft Edge to apply (horizontal or vertical).
You can also position the devices within the screen by scrolling
with the appropriate knob left or right.
3/ Press the Covering tab to control the amount of Soft Edge
covering you need (indicated in pixels). By rotating the
corresponding knob, increase (right) or decrease (left) the
amount of image covering on your Soft Edge.