Analog Way Axion2 - Manual (Page 33)

31
To clear a Logo from your Screen, proceed as follows:
1/
Select the LOGO you wish to clear.
2/ Press the [ CLEAR] button once. In the Axion2 Settings
section, a message will be displayed at the bottom of the touch
screen to confirm your action. Press the [CLEAR] button again
to confirm. The PIP will disappear from the Preview output.
3/ Press the [ TAKE] button to view the result on your Main output.
* TIP * : To clear all logos from your screen, press the [CLEAR
LOGOs] button rather than the [CLEAR] button.
Clearing a logo
Programming a Preset
5-7. WORKING WITH PRESET MEMORIES
The Axion2 automatically detects that the correct software version is in use on the product that it is connected
to. If connecting the Axion2 directly to your product make sure that you use an Ethernet crossover cable.
For programming a preset, here is the configuration to do:
#1- Select a Screen #1 to #6
#2- Create a layer with “Preset Edition” section
#3- Select a source
#4- Save the configuration of the Screen in a Preset.
=> Restart the steps #1 to #4 if several screens are associated to a Preset.
With the Axion2 , you have up to 90 presets memory. Each preset memory can save, at the given time, the exact
situation for 6 screens.
To manage presets memory, just select your screen in the screen section, make your preset for each screen
and then press the [SAVE TO PRESET] button and choose your preset.
If you save in a memory which has already been used, you’ll have several choices for each screen: Save,
Overwrite, reset and No change. Check the box, according to your choice, then press [OK] to confirm and finally
save your preset.
- For saving a Preset with black content, you must save an empty Preset.
- In loading Mode, short press on a preset: loading of all information
saved into the memory and selecting only the relevant screens in
the Transition section.
- In loading Mode, long press on a preset: Loading only the
information concerning the Screens selected in the Transition
section.
- For cleaning a Preset (Memory): Save To Preset => Confirm the reset of the memory on the touch screen.
The check boxes are not automatically checked by the software.
The operator must confirm the action of erasing.