Asus Barebone System Vintage-PE2 - Manual (Page 39)

A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 A S U S V i n t a g e - P E 2 2 - 2 3 2 - 2 3 2 - 2 3 2 - 2 3 2 - 2 3
2.8 Installing a hard disk drive
Refer to this section for instructions on how to install up to four Serial ATA
hard disk drives and/or one 3.5-inch IDE hard disk drive (HDD). One
3.5-inch bay is right under the 5.25-inch bay. The following figures show
the internal and external views of the HDD bay location. Three Serial ATA
hard disk bays are located under the floppy disk drive bay.
I n t e r n a l v i e w I n t e r n a l v i e w I n t e r n a l v i e w I n t e r n a l v i e w I n t e r n a l v i e w E x t e r n a l v i e w E x t e r n a l v i e w E x t e r n a l v i e w E x t e r n a l v i e w E x t e r n a l v i e w
3
To install a Serial ATA hard disk drive:
1. Remove the knock-down plate
cover using a Phillips screw
driver.
2. Place the chassis upright.
3. With the HDD label side up,
carefully insert the drive into
the 3.5-inch bay.
1
I D E / S e r i a l A T A H D D b a y I D E / S e r i a l A T A H D D b a y I D E / S e r i a l A T A H D D b a y I D E / S e r i a l A T A H D D b a y I D E / S e r i a l A T A H D D b a y
S e r i a l A T A H D D b a y s S e r i a l A T A H D D b a y s S e r i a l A T A H D D b a y s S e r i a l A T A H D D b a y s S e r i a l A T A H D D b a y s