Installation instructions, Mitsubishi lancer, Picture 1 – Draw-Tite 24885 SPORTFRAME HITCH User Manual

Page 2: Passenger’s side forward attachment, Part numbers

Advertising
background image

Installation Instructions

Access Hole,

enlarge to

allow block

to fit through

Mitsubishi Lancer

All single exhaust models inc. GT

Part Numbers:

60302, 24885, 77273

Insert Bolt Leader up

through attachment
hole and back down

through enlarged access

hole

Picture 1.

Vehicle Forward

Attachment

Hole

Passenger’s Side Forward

Attachment

INSTALLED HITCH

All you see is the

receiver tube!

Another Fine Cequent Performance Products hitch

© 2012 Cequent Performance Products

Sheet 2 of 6

60302N

5-29-12

Rev. A

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Mount

hitch

bracket to

rear face of

Tow Hook

Tighten 7/16”-Gr.5 Carriage Bolt with torque wrench to 50 Lb.-Ft. (68 N*M), Tighten 5/8”-Gr.5 Carriage Bolt with torque wrench to 150 Lb.-Ft. (203 N*M)

Tighten 8mm bolt to 25 Lb.-Ft. (37 N*M)

Picture 2.

Picture 3.

Driver’s Side Attachment

Passenger’s Side RearAttachment

Remove this 8mm bolt

Advertising