Draw-Tite 118270 OEM WIRING HARNESS - Manual

WARNING
All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed. For initial test, reset vehicle
electrical system by temporarily removing
the key from the ignition.
WARNING
Overloading circuit can cause fires. DO NOT
exceed lower of vehicle manufacturer rating or:
• Max. stop/turn light: (7.5 amps)
• Max. tail lights: (7.5 amps)
Read vehicle’s owners manual & instruction
sheet for additional information.
ENGLISH
TOOLS REQUIRED:
Test-probe
1. Under vehicle hood, locate the vehicle’s
fuse box d . Insert relays and fuses into
positions shown e .
Insert 10 Amp Fuses (Provided) in the
following locations:
Trailer Park Lamp, Position F41
Left Turn Trailer Stop/Turn, Position F21
Right Turn Trailer Stop/Turn, Position F17
Trailer Back Up, Position F8
Insert 30 Amp Fuses (Provided) in the
following locations:
Trailer Brake, Position F34
Trailer Power, Position F30
Insert relays. (included)
NOTE
The use of relays that differ from the relays
included can result in the unit not to function
or may damage the vehicle and or trailer.
Insert Relays (Provided) in the
following locations:
Right Turn Trailer Stop/Turn, Position R16
Left Turn Trailer Stop/Turn, Position R15
2. Locate the vehicle’s towplug located under
the vehicle on the passenger side. Locate
the opening to the right of the vehicle muffler.
Reach up into opening to locate the vehicle’s
grey towplug f . Disconnect the mating
protective cover and discard. Connect the
towplug harness into mating harness. Check
to see that the mating surfaces of the wiring
connectors match. All connector surfaces
should be clean and free of dirt. Be careful
not to damage the locking tabs and be sure
that connectors are fully inserted with
locking tabs in place.
Route the T-Connector harness rearward to the
back of the fascia of the bumper.
WARNING
Route the wire being careful to avoid any hot
pipes, heat shields, the fuel tank or any other
points that may pinch or break the wire.
3. Secure all loose wires with cable tie provided.
4. Secure 4-Flat tow harness to hitch. Bracket not
included.
WARNING
Secure the remainder of the T-Connector
harness under the bumper with cable ties
provided, being careful to avoid any areas
that would cut or pinch the wire.
Installation Instructions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
118270-037 Rev. A 2/5/14
READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.
PAGE 1 OF 3
e f
d
Chevrolet
Traverse
GMC Acadia Buick Enclave