Draw-Tite 50073 CUSTOM QUICK INSTALL BRACKETS - Manual (Page 3)

10. Place the unassembled fifth wheel saddles/slider/goose into the already installed mounting rail. Position the second mounting rail
with the saddles/slider/goose by inserting the tabs into the mounting rail and pushing the mounting rail tight towards the other
mounting rail. Ensure that the mounting rail is centered between the weld seams on the length of the truck box floor. This will
position the mounting rail in the correct location and ensure that the fifth wheel will have a snug fit to the truck. NOTE: If more
than one hitch product will be used with the rails then both should be used at the same time to align the second rail. This will
ensure that one product does not compromise the fit of the other.
11. Repeat steps 5 thru 10 for the other side of the vehicle.
12. Tighten the fasteners in the following sequence: 1) torque the mounting rails to the frame brackets, 2) torque the frame brackets
to the truck frame.
Torque all 1/2" Grade 5 hardware to 72 ft-lbs (98 N-m), M14 - 10.9 hardware to 148
ft-lbs (201 N-m).
13. On 2011 and up Gas Engine Vehicles Only. Use the factory flange nut that was removed in Step 2 to tighten the tube holder
onto the L-bracket as shown in Figure 1c.
14. Reinstall spare tire if it was removed.
z 2010 Cequent Performance Products, Inc. Sheet 3 of 7 50073N 12/10/10 Rev. A