4 bolt installation, Figure 7 – Draw-Tite 50073 CUSTOM QUICK INSTALL BRACKETS User Manual
Page 5
INSTRUCTIONS WHEN USING THE 30124 RAIL KIT
WITH THE 2011 & UP FORD SUPER DUTY F-250, F-350, F-450
HARDWARE AND INSTALLATION IS THE SAME FOR BOTH THE DRIVERS SIDE AND PASSENGERS SIDE
¾
Do not install mounting rails over plastic bed liners. Plastic bed liners must be cut out of the
way to provide metal to metal contact Mounting rails may be installed on spray in liners
4 BOLT INSTALLATION
way to provide metal to metal contact. Mounting rails may be installed on spray in liners.
¾
Use only bolts, nuts, and washers supplied to install this kit. All bolts are Grade 5 and nuts are
Grade 5 unless otherwise specified.
¾
These instructions are guidelines only, actual installation is the responsibility of the installer
and the owner. Always measure truck and trailer before installing hitch to be sure that there is
clearance at the cab and at the bumper to allow for turns.
Equipment Required:
4 BOLT INSTALLATION
Fastener Kit: 50073F
Wrenches: 3/4, 7/8, 15/16, 15 mm
Drill Bits: 1/8”, 11/16”
Other Tools: Center Punch, Measuring Tape
Figure 7
Hardware and
5/8” CARRIAGE
BOLT
5/16” SPACER
FRONT OF
installation shown
is the same for the
passengers side.
1-1/4” TUBE
SPACER
RAIL
FRONT OF
TRUCK
5/8” CONICAL
WASHER
5/8” NUT
FRAME BRACKET
Driver’s side
frame rail
Vapor
b
Driver’s side
frame rail
Existing
flange nut
5
4
6
4
HARDWARE ITEMS LISTED
ARE FROM PAGE 1 CHART
tube
Tube
holder
Figure 7A
Inside of frame rail
Figure 7B
Figure 7C
L-bracket
Existing
flange nut
z
2010 Cequent Performance Products, Inc.
Sheet 5 of 7
50073N
12/10/10
Rev. A