Draw-Tite 59742 TRUCK BED RACK - Manual (Page 4)

Product Code:
Product Name:
4
Please read all instructions carefully before assembly, installation and/or use of this product.
59742
Pick-Up-Rack™
• Remove end cap and under cover from both ends
of crossbars.
5
• Install Adapter Blocks into each end of crossbar.
Under cover
End cap
Adapter Block
Mark Mark
Flange
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
59742N Rev D 4-24-13
Page 4 of 6
Printed in China
6
• Place crossbar onto Vertical Supports and center side-to-side.
• Be sure to align the Adapter Blocks with the Vertical Supports Flanges.
• Mark with pencil the crossbar location on each side of Vertical Support Flange for under cover installation.
• Remove crossbar from vertical supports. Remove adapter blocks from crossbars.
• Measure distance “x” from pencil marks to end of slot as shown above.
• Cut inner under cover to length first (rounded end), then cut outer under cover to length.
• Install under covers, 3/8 x 1.25 carriage bolts, adapter block and end cap to both ends of crossbars as shown.
“X”
“X”
Slot
Bottom view of crossbar
Inner under cover
Outer
under cover
Pencil marks