Draw-Tite 59742 TRUCK BED RACK User Manual
Page 5
Product Code:
Product Name:
7
•
Install crossbars onto Vertical Supports, align carriage bolts with slots in Vertical Support Flanges.
•
Secure crossbars to supports using the 3/8 flat washer, lock washers and hex nuts onto carriage bolts.
•
Securely tighten all 3/8-16 fasteners (approximately 25 Lb.-Ft. )
3/8 Flat Washer
3/8 Lock washer
3/8 Hex nut
(8) Places
59742
Pick-Up-Rack™
Please read all instructions carefully before assembly, installation and/or use of this product.
Optional permanent mounting
Remove end cap and
buffer strip to utilize
Accessory T-Slot in
crossbar
Buffer strip
WARNING
Always secure front and rear of long
loads to ends of vehicle for safe
transport. Failure to do so can result
in property damage, personal injury, or
death.
REMOVE YOUR RACK AND
ACCESSORIES WHEN NOT
IN USE AND BEFORE
ENTERING AUTOMATIC
CAR WASHES
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
59742N Rev D 4-24-13
Page 5 of 6
Optional permanent mounting
Your Pick-Up-Rack™ can be permanently mounted to your truck if you desire. You will need (8) 3/8-16 Grade 5 hex bolts, (16)
3/8” flat washers and (8) 3/8 -16 grade “A” lock nuts. Stainless steel hardware is recommended. Start by placing a piece of tape
on top of the mounting base. Mark the tape as shown below. Place the mounting base on the truck and check that there will be
no interference where the bolts will be placed. Remove the base from the truck and drill the (2) 3/8” holes in the marked
locations on the base. Mark the truck bed rails using the drilled base as a template. Then drill the (2) 3/8” holes in truck bed rail,
4 places.
Place a 3/8” washer on a 3/8-16 bolt and insert it
though the base and truck bed. Install a 3/8” washer
and 3/8-16 nut on the bolt underneath the bed rail and
tighten.
Support Base
3.00”
MAXIMUM
DRILL (1) 3/8” HOLE
THIS LOCATION
1.00”
MINIMUM
CENTER
OF BED RAIL
(1-1/2” REF.)
1.00”
DRILL (1) 3/8” HOLE
BETWEEN 1.0” to 3.0”
CENTER
OF BED RAIL
(1-1/2” REF.)
Printed in China