EBARA EVMU - Manual (Page 2)

Ebara Stainless Steel Vertical Multistage EVMU
Instructions and Operation
Ebara Fluid Handling
www.pumpsebara.com 2
(t) 803 327-5005 • (f) 803 327-5097 rev. 11/10
Manufacturer Information
Section Page
Manufacturer Information 2
1 – General Information and Warnings 2
2 – Specifications 3
3 – Pump Checks & Installation 6
4 – Operation 8
5 – Motor Installation on Bare Pump 10
6 – removing Motor from Complete Pump 11
7 – General Pump Maintenance and Disassembly Instructions 12
Torque Specifications 21
Sectional View 22
EBArA Fluid Handling
1651 Cedar Line Drive
rock Hill, SC 29730
Phone: (803) 327-5005
Fax: (803) 327-5097
e-mail: [email protected]
web site: www.pumpsebara.com
* NSF/ANSI 61 Annex G listed models: EVMU3-18, EVMUL all models 3-64
Section 1 – General Information and Warnings
Before any work is performed on the EVMU pump, care should be taken to ensure
that electric power is disconnected to the motor to prevent electric shock or premature
starting which could cause damage to persons, things or the pump.
Before starting the EVMU pump, make sure that all cables, electrical connections
and controls are in perfect working order and properly grounded. Improper installation
can result in serious or even mortal accidents to persons.
Any electrical work should be preformed by a licensed electrician.
Warning
1.1 The user must comply with all local and national regulations that apply to the installation and
operation of electric pumps. Operation of the EVMU pump must be compatible with the
construction of the pump as shown in the SPECIFICaTION section of these instructions.
!!
1.2 EVMU pumps with motor installed tend to be top heavy, care should be taken in handling and
transporting to prevent damage or injury caused by the pump falling over.