eLine Technology PRO3 Effio E - Manual (Page 18)

33 34
CAMERA ADJUSTMENT CAMERA ADJUSTMENT
ON: Make motion areas visible, OFF: Hide motion areas
ENABLE  Press enter to access the “dead band setting”
screen, on-screen cursor moves in response to the
inputs Left, Right, Up and Down to set the sensing area,
or dead band for specified blocks. This allows you to
specify and set an area of motion which is not
rectangular in shape.
Press and hold SET button 3 seconds to exit.
MOTION AREA: ON / OFF Enable / Disable Area No.
AREA SEL: 1/4 / 2/4 / 3/4 / 4/4. Selects motion area number.
TOP: Set the top side of the monitoring frame selected by the AREA SEL
parameter.
BOTTOM: Set the bottom side of the monitoring frame selected by the AREA
SEL parameter
LEFT: Set the left side of the monitoring frame selected by the AREA SEL
parameter.
RIGHT: Sets the right side of the monitoring frame selected by the AREA SEL
parameter
CAMERA ID OFF / ON
Camera ID shows a name on the screen as chosen.
CAMERA TITLE SETUP
CAMERA
ABCDEFGHIJKLMNOPQRSTUV
WXYZ0123456789-!#$%&’
()_`.:;<=> @^*./^*X+/
CHR1 CHR2
 CLR POS
RETURN
Use Up/Down/Left/Right to move around. CHR1/2 changes the selection fonts to
alternative selection, CLR will clear info. POS allows position change.
LL
PHASE 326
RETURN
SYNC INT / LL 
Video synchronization displayed
INT(Internal) or LL (Line Lock)
Note: Shows INT with DC only model.
And LL setting for camera model
when connected to a AC supply.
PHASE: 000-524
Adjust the phase in the vertical direction when the line
lock mode is available.
CAMERA RESET 
This will reset all settings for all menus to manufacturer
defaults. This allow you to return to shipped settings
from the manufacturer.
EXIT / SAVE ALL
• EXIT Exit OSD menu.
• SAVE ALL Saves the settings to camera
Refer to the following table if you are experiencing trouble with your camera.