eLine Technology PRO3 Effio E - Manual (Page 4)

5 6
NOTE: Make sure you don’t have any missing parts before you make the installation.
Incorrect installation could void the warranty if instructions are not followed correctly.
Please call technical for assistance if you are unsure about any procedures.
Identification
Mechanical Drawing
Installation
Installation information
(General overview)
1 Unscrew the thee tamper screws to release the dome cover.
Now turn dome anti-clockwise will release base, from locking lungs.
2 Using the base as a drilled template. pre-drill all requires holes.
Fit the optional base place (A) if required to use a 4S Junction Box
3 Fitting back internal part is twist lock into place, use conduit for power if required.
4 Move camera module, and use Levels to adjust zoom/focus, twist to lock into place.
5 Reifit dome cover and screw back the three tampers, this locks dome water tight.
6 Give cover a wipe clean just to remove smudges from the dome cover.
Check IR LEDs are working by covering the photocell of camera with your thumb
your thumb, the IR LEDs will give a faint red glow. (not all models have IR LEDs)
(Don’t look at IR LEDs for long periods of time, as you could damage your eyes)
Accessories
(B) Fitting Screws
PA4 x 35mm 4pc (A) Wall Plugs
S8 x 30mm 4pc
1
4 3
2
5 6
4S Mounting Plate
Base Fitting Underside
4S Junction Box Fitting
83.5 mm
3 1/2 in
46.0 mm
2 in
Ø 98.0 mm
4 in
3/4’’ -14
NPS thread
4.4"
(112 mm)
5.1"
(130 mm)