eLine Technology SIP-D - Manual (Page 17)

23 24
Web Configuration
6.5 Device Info
The Device Info page shows information about your IP camera, such as the
Device Name (which appears in the Device List in NVMS), firmware
version, MAC address, and camera inputs and outputs. You can also
configure the Device Name for your camera.
ATTENTION: The device ID is unique. Do not change it unless your
installation has special requirements.
To configure the Device Name:
1. Click Device Info.
2. Under Device Name, enter the desired device name and then click Set.
Web Configuration
6.6 Stream Configuration
The Stream Configuration page allows you to configure the camera’s video
streams. The camera supports three different video streams. This allows
you to have a high quality recording stream (stream1), a lower quality stream
(stream2) to preserve bandwidth for remote connections, and an MJPEG
stream for applications requiring MJPEG.
To configure video streaming settings:
1. Click Stream Configuration. Under Stream ID, select the stream you
would like to configure.
2. Configure the following:
• Video Encode Type: Select the Video Encoding type for the stream.
Stream1 and stream2 can be configured for H.264 High Profile, H.264
Main Profile, or H.264 Base Profile. Stream3 supports MJPEG only.
• Audio Encode Type: Select the Audio Encoding type for the stream:
G711_ALAW, G711_ULAW, or RAW_PCM.
• Resolution: Select the resolution for the stream. Stream1 and stream3
can be set to 1920x1080 or 640x360. Stream2 can only be set to 640x360.
Stream3 can only be set to 1920x1080.
eLineTechnology.com