eLine Technology SIP-D - Manual (Page 8)

5 6
Connection
3. CAMERA INSTALLATION
Camera Installation
Initial camera removal
1a) Press down on the tab marked with
an arrow to lift up the dome cover
slightly
1b) While pressing on tab, twist the
dome cover counter clockwise just a
few degrees to release dome cover
from back clips.
Lift off the cover.
3a) Reinsert camera
module into camera base
by aligning the arrow
notches, and turning
camera module clockwise
to lock into place.
3b) Reinstall the base
locking screws. (indicated
by padlock markings)
Skip to next Page
Method 1 - Direct Attach Install
2a) Use included mounting template
to mark and pre-drill the required
holes. Use included 2.8” screws to
mount the camera directly to the
mounting surface.
Skip next page to finalise installation
OR
Method 2 - Camera Base Install
2b) Use the included mounting
template (Installation Option 1)
to mark and pre-drill the required
holes. Remove the camera base
by unscrewing the base locking
screws (indicated by padlock
markings) and turn camera module
approx. 5 degrees counterclockwise
to detach camera base from the
camera module. Install the base as
indicated using the 1.2” screws.
Method 3 - Recess Mount
a) Cut semi flush mounting
hole into surface using
provided Semi-flush
Mount Cut-out Template.
Note: Always cut using the
inside line of the cutout
template
b) Insert camera into cutout.
Make sure that the
mounting arms are not
extended.
c) Turn screwdriver
clockwise to unlock all of
the 3 mounting arms.
d) Continue turning
clockwise to move
mounting arms down until
they make contact with
inner mounting surface.
Note: Once mounting
arms have made
contact with the inner
mounting surface, do
not apply too much
pressure to avoid
damaging surface.
a
b
2
3
a
b
1
a
b
d
c
b
2
eLineTechnology.com