EXP Computer CD-820_CDG-820 - Manual (Page 20)

BASIC OPERATING PROCEDURES
Follow the instructions listed below to open the disc cover and insert/remove a CD.
1. Press the OPEN button. The disc cover will open slightly, and the ON/BUSY
LED will blink as a warning signal.
2. If there is no disc inside, go to next step. Otherwise, wait until the drive stops
spinning. You may check if the disc stop by looking through the disc cover
window.
3. Lift the disc cover by the edges as shown in Figure 24.
4. Insert the disc with the label side facing up or remove the disc.
5. Close the disc cover.
CAUTION
Do not lift the disc cover until the drive stop spinning. Failure to
do so may damage the CD disc.
Figure 24