EXP Computer ThinCD - Manual (Page 6)

- 6 -
REAR PANEL
1. Power Button:
Press the button to manually power on/off the drive when it is powered
by an AC adapter.
2. DC in Jack:
This jack connects to the AC adapter.
3. Power Source Switch:
This switch is used to select the power source. When the Switch is set to
“PC”, then PCMCIA power direct is selected. When it is set to “DC”,
an AC adapter is required to power the CD-ROM.
4. Interface Connector:
Connect the drive to the PCMCIA interface card or Parallel interface
cable.
5. Audio Line-Out Jack:
Send audio signal to an external amplifier.
Figure 2