Biamp TTS-1nc User Manual
Page 9
9
INSTALLATION
Installation
The TTS-1 requires one 1.75 inch (44.45 mm) high and 19 inch (483 mm) wide rack space with 17inch (432 mm) depth. Mounting the unit
using four screws with washers will prevent marring of the front panel. PVC or nylon washers are appropriate.
When installing the rack ears, please note that the hardware is not symmetrical. Please install the rack ear labeled “left” on the left side of
the TTS-1 (when looking at the equipment facing the front plate) and the rack ear labeled “right” to the right of the unit.
• First, remove the screw from the TTS-1 chassis (with a Phillips P2 screw driver)
• Attach the appropriate rack ear and re-affix the Phillips screw to the chassis and 4 additional Philips screws supplied with the rack ears.
Please install the unit away from heat sources, such as vents and radiators, and in rooms with adequate ventilation. Ensure that air can
circulate freely behind, beside, and above the unit. Do not exceed the maximum ambient operating temperature of 113 degrees F (45°C).
Be aware of conditions in an enclosed rack that may cause the temperature to exceed ambient room conditions.