BJM Pumps SX75CSSF-575T - Manual (Page 6)

6
The following are recommended installation practices/procedures for the pump. If there are
questions in regards to your specific application, contact your local BJM Pumps distributor or
BJM Pumps, LLC.
PRE-INSTALLATION INSPECTION
1) Check the pump for damage that may have occurred during shipment.
2) Inspect the pump for any cracks, dents, damaged threads, etc.
3) Check power cord and sensor cable for any cuts or damage.
4) Check for, and tighten any hardware that appears loose.
5) Carefully read all tags, decals and markings on the pump.
6) Important: Always verify that the pump nameplate, amps, voltage, phase, and HP
ratings match your control panel and power supply.
Warranty does not cover damage caused by connecting pumps and controls to an incorrect
power source (voltage/phase supply). Record the model numbers and serial numbers from the
pumps and control panel on the front of this instruction manual for future reference. Give it to
the owner or affix it to the control panel when finished with the installation.
If anything appears to be abnormal, contact your BJM Pumps distributor or BJM Pumps, LLC.
If damaged, the pump may need to be repaired before use. Do not install or use the pump until
appropriate action has been taken.
Lubrication:
No additional lubrication is necessary. The shaft seal and bearings are fully lubricated from the
factory. Seal oil should be checked once per year. See table below.
OIL FILL QUANTITY/TYPE
OIL IN SEAL CHAMBER
MODEL U.S. FL. OZ. CC. TYPE OF OIL
S08C-F 7.8 230 ISO 32 NSF Food Grade Mineral Oil
S15C-F 7.8 230 ISO 32 NSF Food Grade Mineral Oil
S22C-F 11.8 350 ISO 32 NSF Food Grade Mineral Oil
S37C-F 11.8 350 ISO 32 NSF Food Grade Mineral Oil
S55C-F 35.5 1050 ISO 32 NSF Food Grade Mineral Oil
S75C-F 35.5 1050 ISO 32 NSF Food Grade Mineral Oil
OIL IN SEAL CHAMBER
MODEL U.S. FL. OZ. CC. TYPE OF OIL
SX08CSS-F 10.1 300 ISO 32 NSF Food Grade Mineral Oil
SX15CSS-F 10.1 300 ISO 32 NSF Food Grade Mineral Oil
SX22CSS-F 13.5 400 ISO 32 NSF Food Grade Mineral Oil
SX37CSS-F 13.5 400 ISO 32 NSF Food Grade Mineral Oil
SX55CSS-F 35.5 1050 ISO 32 NSF Food Grade Mineral Oil
SX75CSS-F 35.5 1050 ISO 32 NSF Food Grade Mineral Oil
NOTE: The stator on this model is oil filled. This needs to be changed annually when the seal oil is
changed. With the power cable entry removed, fill the motor chamber with oil to a level that insures the oil
is covering the motor windings by ½”, and that will be above the upper bearing. Do not overfill, an air gap
of 10-15% must be maintained for heat expansion.