Burkert Type 6519 - Manual (Page 17)

6518 / 6519 - 15
I
NSTALLATION
, I
NITIALISATION AND
S
ERVICE
english
Mounting single valves
Fix the single valve directly to the wall using M4 screws. (Figure: Insstallation, Initialisation and Service
- Mounting single valves,
NOTE For plug-in connections, the hose lines must meet the following requirements:
• Minimum rigidity of 40 Shore D (to DIN 53505 or ISO 868);
• External diameter corresponding to DIN 73378 (max. permissible deviation ± 0.1 mm
from nominal dimension);
• Without burr, cut at right-angles and with undamaged circumference;
• The hose lines must be pushed into the plug-in connectors up to the stop.
Plug-in connections
Dismantling the plug-in connections
To release the line, press in the pressure ring and pull out the hose line.
Manual override
For manual operation of the valve depress the
manual actuator to the stop. The manual
actuator is then locked by turning 90° to the
right.
Indicating pin for indicating the pneumatic
position
With the valve not switched, the red indicating
pin can be pressed in. If the valve has been
switched, the indicating pin moves outwards,
and remains in this position. The indicating pin
must be pushed in again for every functional
test.
Designation plate (can be removed for marking
/ engraving)
Port 14
•
not used in the standard model
• used as an auxiliary pilot air connection
and as the connection for pneumatic
controls
Service ports
2 (B) and 4 (A)
M4 screws
for wall mounting
the single valve
Figure: Mounting single valve / Fix the single valve directly to the wall using M4 screws.
ATTENTION!
When mounting, do not distort the valve body!