Burkert Type 8630 - Manual (Page 102)

100 - 8630
O
PERATING THE PROCESS CONTROLLER
Teach-In funktion:
Calibration of the k factor by measurement of a certain quantity of fluid.
Start of measurement
- Open the valve. Close the valve when the tank is filled.
- Use the arrow keys for opening and closing the valve. For this the valve must
not be fully open.
End of measurement
Position of the decimal point for entry of the volume measured
(setting range: 0..3).
Enter the volume measured (setting range: 0..9999).
Unit as selected before under
UNITXXXX.
Display of the calculated K factor.