Safety settings on bus failure – Burkert Type 8630 User Manual
Page 120
118 - 8630
P
ROFIBUS
DP
Safety settings on bus failure
The actuator moves to the position corresponding to the setpoint last transmitted (default setting).
For other setting options (see the chapter
Settings on the TOP Control Continuous)
The protocol sequence corresponds to DIN 19245 Part 3.
GSD file
BUERC630.GSD
Bitmap files
BUEC630.DIB
BUEC630N.BMP (for Siemens COM-PROFIBUS)
BUEC630D.BMP (for Siemens COM-PROFIBUS)
PNO-ID
C630 Hex
Baud rate
max. 1.5 Mbaud
(automatically set by TOP Control Continuous)
Sync and freeze mode
not supported
Diagnosis telegram
no device-specific diagnosis
Parameter telegram
no user parameters
Configuration of the process data is performed in the TOP Control and in the PROFIBUS Master.
A maximum of 10 process values (sum of input and output) can be transferred.
Technical data
General notes
he following functions are invalid for the TOP Control Continuous with PROFIBUS DP:
•
INPUT
• CAL.USER / CAL INP
• CAL.USER / CAL OUT
• CAL.USER / CAL SP