Burkert Type 8645 User Manual
Page 4
12
GB
INSTALLATION
CAUTION!
Danger due to electromagnetic fi elds!
If the FE connectors are not connected, the EMC-law condi-
tions are not adhered to!
Pay attention to the correct positioning of the gaskets
around the electronic and pneumatic components.
•
Start with the fi eld bus / multipole module.
The sequence of modules is random to the right of the
fi eld bus / multipole module.
A) Wall mounting
8
FE contact
(connect via FE rail)
8a FE rail
9
Screw (separate FE
connection)
10 Mounting straps
13
GB
Proceed with wall mounting as follows:
fi rst, fasten the fi eld bus / multipole module to the two
mounting points on the wall
remove the blue connection bracket
unbolt the 3 pinlocks (module) (see illustration: DIN-track
assembly)
then push the next module onto the fi eld bus / multipole
module
fi x the module to the wall (as above)
connect the modules by pressing and turning the 3
Locking bolts (modules) to the right (90°). (Exception:
Terminal module)
install all the modules in the same way
Block open the blue connection brackets between all
the modules
install the FE connection on the front of the fi eld bus
module
connect the FE contacts (8) via the FE rail
connect the FE rail to FE
→
→
→
→
→
→
→
→
→
→
→
14
GB
B) Mounting on a DIN rail
11
DIN rail mounting
12
Locking pins (modules)
The FE contacts on the modules are connected via the
DIN rail that also has to be connected to FE.
The screw (9) on the fi eld bus module is connected
to FE separately.
15
GB
Proceed with rail mounting as follows:
install the modules from left to right
remove the blue connection bracket
unbolt the three pinlocks (module)
open the DIN rail mounting
place the module onto the DIN rail
push the module to the left up to the block (This point does
not apply for the fi eld bus / multipole module.)
connect the modules by pressing and rotating the 3
locking bolts (modules) to the right (90°) (Exception:
Terminal module)
screw on the DIN rail mounting tightly,
install all the modules in the same way,
block open the blue connection brackets between all
the modules.
→
→
→
→
→
→
→
→
→
→