Burkert Type 8650 - Manual (Page 9)

32 GB
Tools and torques
Application Type and size of
the tool Torque
Actuation of the locking
elements Plain screwdriver,
size 5 -
Screwing on the clamping
bolts onto the supply
modules,
bolts of the terminal module
- Pneumatic module Plain screwdriver,
size 7 1.3 ...
1.5 Nm
Installation / removal
of the valves with 11 mm
stacking size Cross-head
screwdriver,
size 0 0.2 Nm
Installation / removal
of the valves with 16.5 mm
stacking size Cross-head
screwdriver,
size 1 0.3 Nm
Tightening the inclined tie
rods 3 mm Allen Key 0.6 Nm
33 GB
Removing /hooking a preassembled system
from an S7 profi le rail
Illustration:
Hooking onto the profi le rail
Removing:
Loosen (by turning in anti-clockwise direction) all the
clamping bolts (11) on the supply modules.
Now swing the system out of the profi le rail.
Hooking:
Move all clamping bolts (11) on the supply modules into
their starting position by turning in anti-clockwise direction
up to the stop.
Now hook the system onto the upper edge of the profi le
rail at the desired position and swing it into place.
Then tighten all the clamping bolts (11) by turning in
clockwise direction (prescribed torque 1.5 Nm).
→
→
→
→
→
34 GB
Installation / removal of the ET 200iSP™ modules
on S7 profi le rail
11 Clamping bolts
15 Releasing slide
Illustration:
Clamping bolts
11
11
11
15
Installation
The ET 200iSP™ modules (terminal modules) can be
placed onto the profi le rail and latched to the AirLINE
Ex System.
Lock modules fi tted on the right-hand supply slice with the
supply slice.
Disassembly
For dis assembly, prise out the releasing slide
(15) on the supply slice using a plain screwdriver.
This will release the latched module. Push it away to the
right.
→
→
35 GB
Expansion of an existing system
with individual slices
Illustration:
Adding slices
Two inclined tie rods (19) connect each of the modules.
When you have fi tted two modules onto the profi le rail
and pushed them together, screw the right-hand module
to the left-hand module with two inclined tie rods. (3mm
Allen key: 0.6 Nm)
Further modules can be added on the right in the same
way.
Finally retighten the clamping bolts of the modules as
described above.
→
→
→