ADIC FCR 200 - Manual (Page 60)

4-20 Installation
62-9301-01
Connecting the Power Cord
The power cord shipped with the FCR200 is a 120 VAC three-
conductor power cord for use in the United States or Canada.
If you are planning to use another input voltage or if you plan
to use the FCR200 outside of the U.S. or Canada, you must
supply your own power cord.
To connect the power cord to the FCR200:
1 Make sure the FCR200’s power is switched off. See
Figure 4-17 for the location of the power switch on
the back of the router.
2 Connect the female end of the power cord to the
power connector on the back of the FCR200.
3 Plug the male end of the power cord into the power
source.
Figure 4-17 FCR200 Power Switch and Outlet