ADIC FCR 200 User Manual
Page 91
Download Firmware
6-19
FCR200 Configuration
Version: X.X.XXXX
1) Perform Configuration
2) Display Status of Power-on Self Test
3) Display Trace and Assertion History
4) Reboot
5) Download a New Revision of the Firmware
Command >5
Download Firmware Menu
This will replace the current version of the firmware.
A reboot will also be performed as part of this process.
Are you sure (Y/N)? y
Please begin xmodem firmware transfer ...
___________ (transmit Firmware image via XMODEM)
Performing Power-on Self Test ...
(...)
Self Test completed successfully
Select which mode to boot :
1. Fibre Channel/SCSI Router
2. Diagnostic Monitor
Seconds left 1 : 1
Verifying Firmware Checksum ...
Updating Firmware ...
Target Name : ADIC
Attaching Network interface lnPci0 ... Done
Attaching Network Interface lo0 ... Done
NFS Client Support not Included.
Initializing sioc ...
SCRIPTS start @ 0x88002000 (3520)
BRIDGE: Bridge Timed Out SCSI Req on Bus 0 Target 0 LUN 0.
Check Cable.
Initialized Successfully