Burkert Type 8071 - Manual (Page 15)

15
InstallationandWiring
Type 8071
7.3. Wiring
danger
risk of injury due to electrical voltage.
• Shut down and isolate the electrical power source before
carrying out work on the system.
• Observe all applicable accident protection and safety regula-
tions for electrical equipment.
• Use a high quality electrical power supply (filtered and
regulated).
• Make sure the installation is equipotential.
red wire Power supply (+)
black wire Power supply (-)
White wire NPN transistor output
yellow wire Reed switch
Green wire Reed switch
Table 1: Connection wire assignment
7.3.1. Wiring the npn transistor output and
the reed switch output
X
V DC
L+ (4,5 - 24 V DC)
(red wire)
L- (black wire)
NPN transistor out-
put (white wire)
R
yellow wire
green wire
R=1,8 kW pull-up at 24 VDC
Fig. 5: Wiring of NPN transistor output and the Reed switch
output
8071
X V DC
NPN
L-
L+
+ - IN
Remote transmitter
IN = pulse input on remote transmitter
Fig. 6: Example for the connection of the NPN transistor output to
a remote transmitter
English