Alamo TS-100A - Manual (Page 64)

© 2005 Alamo Group Inc. Section 7 - 4
Maverick (NH TS-100A,115A, 125A, 135A Asy. Man) 01/05
Installing Auxiliary Wheel Weight Kit.
1. The Auxiliary Wheel Weight is made up of three steel plates and mounting hardware. Each
Auxiliary Weight weighs approx 136 lbs. When all three are installed on the existing 1400 lb. weight it
will increase the wheel weight by 408 lbs. This makes the total bolt on wheel weights equal 1800 lbs.
This will not include the amount of weight to the tire from the installed liquid which, will vary with the size
of the tire and the liquid that is added.
Auxiliary. Wheel Weight Kit No. 02976671
Qty Part No. Description
2 00012200 Lockwasher, 7/8"
2 00012300 Nut, 7/8" NC
2 00760266 Bolt, 7/8"-NC X 5-1/2 GR8
3 02976644 Auxiliary Wheel Weight Plate, 136 lbs Each
2. Install Auxiliary Wheel Weights. The Auxiliary Wheel Weight bolt to the larger 1400 lb. wheel
weight. There are two slots in the large weight that the 7/8" bolt heads will slide into. It is recommended
that the tractor wheel is in position so these two slots has one facing front and one to the rear. Slide the
two 7/8" bolts into the slots, the slots will prevent the heads of the bolts from turning. The Bolts in the
large wheel weight will have to be aligned to the proper distance apart, to match the distance of the holes
in the auxiliary weights. Slide the auxiliary weight over the two bolts, do this with all three weight for this
kit. Install the lockwashers and hex nuts. Tighten the bolts to required tightness. See bolt torque charts
in tractor preparation section.
Figure 4
Auxillary Weight
Attaching Stots
Wheel Weight
P/N 02970758
Figure 5
Auxiliary Rear Wheel Counter Weight