Fluid Components International MT86_MT86HT Manual Troubleshooting - Manual (Page 15)

Doc. No. 003162 Rev. F 5 - 15 Models MT86, MT86HT
CHAPTER 5 - TROUBLESHOOTING FLUID COMPONENTS INTL
Figure 5-5. Input Board
Spares
FCI typically recommends one or more complete sets of spare PWBs and flow element assemblies depending on how
critical the monitoring process is. Also recommended is the FC81 field calibrators for convenience. Contact the
field representative or FCI for specific recommendations and part numbers. See Table 5-9 for spare parts and Table
5-10 for the recommended special test equipment. When ordering the PWBs the part dash numbers also need to be
given to the factory. The dash numbers can be obtained by looking at the existing hardware or by looking at the
Order Information Sheet that was filled out at the time the flowmeter was ordered.
Table 5-9. Recommended Spare Parts
Table 5-10. Recommended Special Test Equipment
QTY DESCRIPTION
1 Power supply board P/N 011528-XX or 012059-XX for DC
1 Control Board P/N 01552-XX
1 EPROM with additional calibration (see factory)
1 Optional Output Modules: mA/DC voltage board P/N 011563-XX
Switch point board P/N 011581-XX
Remote board P/N 012576-XX
1 Input board P/N 011515-XX
1 Lithium Battery (see factory for part number)
QTY DESCRIPTION
1 Model FC81-8 Field Calibrator for MT86 (1000 Ohm RDTs)
1 Model FC81-7 Field Calibrator for MT86HT (100 Ohm RTDs)
1 Document Number 003169 - FC81 Operating Manual