Fluid Components International ST75 PDA Software - Manual (Page 21)

FLUID COMPONENTS INTERNATIONAL LLC ST50/ST75 PDA SOFTWARE
Appendix A
Using The Configuration Software Quick Users Guide –IR Operation
Set the JP5 jumper on the ST50/ST75 in the “IR” position. This jumper is located under the bezel on the LCD display board. The
“IR” jumper position is located closest to the LCD display.
Selecting the Pipe Size
1. Tap “SETUP”
2. Tap “Line Size” 3. Select Plenum Type
4. Tap “Get All”
5. Enter Dimension
6. Tap “Set”; Tap “Return”
Changing Units
1. Tap “SETUP” 2. Tap “Units” 3. Tap “Get”
4. Select desired Units &
Tap “Set”, Tap “Return”
Setting Pulse Output Channels as Alarm Outputs
1. Tap “SETUP” 2. Tap “Output Config” 3. Tap “Pulse Out Setup” 4. Select “Flow Alarm”
5. Enter Set point Value
6. Select “Pulse Transition”
This page is subject to proprietary rights statement on last page. 19 06EN003372 Rev. A