Grace Digital GDI-IRA500 Solo - Manual (Page 13)

13
Back Panel connections
There are three connections on the back panel.
1) The jack for the power adapter. Please plug the supplied power adapter into the radio’s power
adapter jack then plug the other 2 prong end into the wall.
2) Stereo headset jack connection. The headset jack connection can be used to listen to music
in private via your personal headset/headphones (not provided).
3) Stereo RCA jacks. These connections connect to your stereo’s audio input jacks or powered
speakers.
Steps for Connecting Your Radio to Your Wireless
Network
Getting Started
Step 1 - Power up the radio - 1
st
time set up
Connect one end of the AC Power cord to the back of your SOLO and the other end to the available wall
plug. The radio can be switched on or off with the STANDBY/ON button. The STANDBY/On button is
marked on your radio with this symbol
. If only the clock is displayed on the top of the display, the unit
is in standby mode. Please turn the radio on before going to the next step.
CAUTION: Use only the power adapter supplied with SOLO. Connecting a power supply with a different
rating will cause permanent damage to SOLO and may be hazardous and will void the warranty.
After you turn the radio on it will briefly display the following:
Grace Digital Radio
After a few seconds, the screen will change to show: