Grace Digital GDI-BTSP200 BT Speakers User Manual
Page 3
18.
Servicing: Do not attempt to service the product yourself, as opening or removing covers may expose you to
dangerous voltage or other hazards. Refer servicing to qualified service personnel. Remove the power plug form the main power
source or wal
l
power source when not in use. When plugged
into
a power source, the system remains in standby mode and thus
power is not entirely off.
19.
Replacement parts: when replacement parts are required, ensure the service technician uses replacement parts
specified by the manufacturer. Unauthorized substitutions
may
result in fire, electric shock or
other
hazards.
20.
Main fuses: for continued protection against fire hazard, use fuses only of the correct type and rating. The correct
fuse
specification for each voltage range is marked on the product.
21.
Volume Adjustments: Do not tum up the volume while listening to a section with very low level inputs or no audio
signals. The speaker may be damaged when a peak level section is suddenly played.
22. Power Supply: to completely disconnect the product from the power supply remove the power cord from
the
wall outlet or the
product. The wall outlet or the power cord entry to the product must remain accessible while the product is in use. Try to install the
product near a wall socket or extension cord and in order to be easily accessible.
23. Ambient Temperature: highest environmental temperature suitable for this product is 40C/110F.
ADVISORY
This Product is intended for North American markets. The BTSP200 Series by Grace Digital is in
compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC
ADVISORY
FCC Compliance and Advisory Statement: This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this
device must accept any interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, If not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
To comply with FCC RF exposure compliance requirements, a separation distance of at least 20 cm must
be maintained between the antenna of this device and all persons. This device must not be co-located or
operating in conjunction with any other antenna or transmitter.”
WARNING
This product may contain chemicals listed in
Proposition 65
that may be known to cause cancer, birth
defects or other reproductive harm
Grace Digital Inc., San Diego, Ca.
The aptX software is a copyright to CSR plc or its group companies. All rights reserved. The aptX mark
and aptX logo are trademarks of CSR plc or its group companies and may be registered in one or more
jurisdictions. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
and ay use of such marks by Grace Digital Inc is under license.
Designed in California, Assembled in China.